Now this is something that I would love to see in a Multi-filament system. I tried it with the Prusa MMU3 but found the issue to be with the way the filament is tensioned. In the MMU, all the filaments must be similar to be gripped properly. Harder filaments were gripped too hard and deformed […]
This website contains affiliate links that we are paid commissions from if you click them and purchase products. Power Loss Power Loss can happen for many reasons. For me, it is the recent heavy weather and wind or the multiple power splitters employed in my office sometimes getting bumped. (The outlet near my desk reminds […]
I personally update flow rate calibration every time I change to a different filament as well I also print a Temp tower. These two things set me up for success in printing with different filaments. It takes a few hours but I write down the numbers to use the next time I use the same […]
Below is the E-Steps Calculator, for your convenience, it is located near the top of the page. This is for calibrating the steps of the extrusion motor for your 3D Printer without removing the extruder or Bowden tube from the hot end. The full instructions and description of the operation are located below the calculator. […]
